859
Bearbeitungen
LittlePrinter: Unterschied zwischen den Versionen
Info on how to connect the FTDI board.
HKay (Diskussion | Beiträge) K (Add "U-Boot>" string to indicate commands and prompt feedback of uboot) |
HKay (Diskussion | Beiträge) (Info on how to connect the FTDI board.) |
||
|
The rest is voltage regulation and logic
To connect to the board via a serial link I used the "SparkFun FTDI Basic Breakout". The RX,TX and ground pins are indicated in the picture above. Connect "RX"(receive pin) to the "TX"(transmit) pin on the FTDI board and the other way around. Also connect GND to GND. Make sure you have the 3.3V version as the 5V version would likely fry the board.
=== Software ===
| |||